Cross Flow Scrubber  
 
The unit's capabilities to remove the following contaminants:
1. Soluble gases (Acid, Alkaline e.t.c)
2. Liquid Particulates
3. Solids Particulates
4. Odor
 

Equipment Description:

KMC provides PVC, PP or FRP in equipment construction for corrosion resistance. The FRP is composed of about 30% by weight of glass and other fibers and about 70% by weight of corrosion resistant Polyester or Vinylester resin. The PP (also available in PVC, PE, PVDF) made packing offers effective surface area which is created by countless interstitial holdup points where droplets are formed and reformed constantly, exposing fresh liquid to the gas stream.

The demisters maximum efficiency ceach to 99%. The construction features including recycle sump, manhole and access door and inspection ladder to ease the necessary maintenance. KMC designed Cross flow scrubber is capable for the gas removal either individually or in various combinations.
 

Design Considerations:

I.  Stanrdard Shell
1. The equipment side, the base and the wall surface must withstand the pressure which Fume Exhauster produces.
2. The top is designed to support one man.
3. Inside and outside the equipment has the biggest corrosion resistivity.
4. Access manholes and internal supports attached to the shell are designed to withstand all expected stresses and corrosion resistance.
 

II. Sump
The bottom of scrubber connects with an integral sump. The use of an integral sump gives a completely unitized, corrosion resistant scrubber at minimum cost.
 

III. Liquid Distribution System
The scrubbing liquid is usually. To obtain the best possible liquid distribution. Spray header assemblies with low pressure. Large office spary nozzles are used, will achieve designed scrubber efficiency.
 






































Table of Dimensions Scrubber Selection